User Manual

OPTIONS FOR VENTILATION

This hood can be set up for either external venting or recirculation of the air. The type of setup

should be decided before commencing installation.

EXTERNAL VENTING

If you have an outlet to the outside, your cooker hood can be

connected as shown in the diagram using the flexible exhaust

pipe (supplied). Alternatively any suitable extraction duct

(enamel, aluminium, flexible pipe or inflammable material

with an interior diameter of 150mm) can be used.

An adaptor is also supplied to enable you to connect your

hood to pre-existing 120mm diameter ducting.

If this is the chosen installation method consideration to the

route of the vent pipe should be made prior to installation.

RECIRCULATION

This cooker hood also supports the recirculation of air once it has

passed through the filters. The filtered air is then expelled through

the vent holes in the side of the chimney.

When setting the unit up in this configuration, carbon filters should

also be used to remove odors from the air. Details of sourcing and

fitting the filters can be found in the Carbon filter section.

When setting up for recirculation the installation instructions should

be followed, but the vent pipe should not be attached, and instead

the air can be routed back into the room through the top of the unit.

UNPACKING YOUR APPLIANCE

• Please take great care when unpacking; a sharp blade should not be used to open the

box, as it may go deep enough inside to damage components. Components damaged

or marked by careless unpacking are not covered under the guarantee.

• Carefully unpack the contents and check against the next section (Product overview –

parts supplied)

• Packaging materials should be recycled in accordance with local regulations