User Manual

8
6. Plate I and II are used to fix the chimney onto the wall.
Put the inner chimney into the outer chimney. Mark
the position for plate II. Then pull the inner chimney
upwards to the desired height, and mark the position
of plate I.
7. Drill holes to accommodate plate
I & II, and insert wall plugs.
8. Fix plate II on the wall using two
screws (4mm x 30mm).
9. The 2 x air flaps should be installed at this stage, as access is easier before the unit is wall
mounted. On the top of the Hood Unit itself, where the air outlet vent is located, the 2 x
flaps should be carefully installed, bending very slightly so the lugs at each end locate into
the holes, enabling flaps to pivot upwards when the unit is in operation, opening up the
outlet fully for the air to pass through. Please note – the small spindles/lugs at each end of
each flap locate into the holes on the housing, not the grooves above them: