User Manual

INSTALLING THE CARBON FILTER (OPTIONAL)

1. Remove the grease filters from the underside of the hood.

2. The carbon filters are located at either end of the motor.

TO FIT: Locate the filter on the peg on the side of the motor. Rotate the

filter clockwise onto the motor housing;

TO REMOVE: Rotate the filter anti-clockwise until it is unscrewed.

WARNING: The carbon filter cannot be washed or recycled. It should be

replaced after approximately 2-3 months of use.

When the activated carbon filters are attached, the suction power will be

reduced.

NOTE: The optional carbon filter is available from the hood

supplier/manufacturer under the following stock code: eiQMIDCARBON