User Manual

8
does not drop down whilst the main body of the hood to the angle bars.
5. On the top of the hood unit, where the air outlet vent is located, the 2 x air
should be carefully installed, bending very slightly so the lugs at each
end the holes This enables to pivot upwards when the unit
is in operation, opening up the outlet fully for the air to pass through.
Please note: The small spindles/lugs at each end of each the
holes on the housing, not the grooves above them:
6. Lift the main body of the cooker hood
onto the angle bar and then it into
position using the 16 x M5 screws.
:
This stage of the installation process MUST
be completed by two people, as one person
must support the weight of the hood until all
16 of the M4 screws have been securely
tightened.
8. The unit should then be connected to a suitable power source, either by
using the supplied plug, or hardwiring the unit into a spur. Please note if
hard wiring the unit, a suitable switch should be in a conveniently
accessible position.
9. Remove the hanging hook and
then slide the lower chimney
section downwards, until it rests
against the main body of the
cooker hood.