User Manual

CLEANING THE FILTERS

• Remove the filters by pulling the latch until the

filter cover comes off.

• Put into a dishwasher with detergent, set the

temperature below 60 degrees. Or wash by

hand with warm soapy water, making sure to dry

thoroughly.

• Make sure that the hood is disconnected from

the mains before cleaning or maintenance.

Replacement grease filters are available from the

same stockist from which you purchased the hood

under the following reference:

eiqfled

REPLACEMENT FOR ACTIVATED CARBON FILTER

These are only required in units that have been installed in recirculation mode. This

filter traps odours and must be replaced ideally every 3-6 months depending on how

frequently the cooker hood has been used. They are not washable or reusable.

Replacements are available from the retailer the hood was purchased from under

reference: eiqcf120

1. Insert the carbon filter into the rectangular hole, fitting it over the motor.

2. After inserting the front edge of the carbon filter into the slot on the cooker hood.

Lower the back edge of the carbon filter, until it clicks into place at the rear of the

rectangular hole. Raise the two fixing bars, until they are horizontal over the

carbon filter.

3. Place the Al. filter back to position.

4. Apply reverse procedure to uninstall the carbon filter.

NOTE:

• Make sure the filter is securely locked. Otherwise, it would loosen and cause

dangerous.

• When activated carbon filter attached, the suction power will be lowered.