User Manual

OPERATING INSTRUCTIONS

BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE

PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL DIAL ANTI-CLOCKWISE TO THE

PILOT SETTING. PRESS THE DIAL IN AND HOLD FOR 1 MINUTE BEFORE ATTEMPTING IGNITION.

BATTERY REPLACMENT

Remove the control dial. Install 1 AA battery. The negative end of battery goes in first, then replace the control dial.

LIGHTING THE PATIO HEATER

• Check all connections prior to each use.

• Turn on the gas supply at source.

• Press and turn the control dial anti-clockwise to the IGNITE marking.

• Keep control dial depressed for up to 20 seconds until pilot is lit.

• If the gas fails to ignite, press and turn the dial clockwise to OFF before

repeating the lighting steps.

• Turn the dial further anticlockwise to the LOW position.

• Adjust the heat by turning the dial from the LOW position to the HIGH

position as required.

• In the event of the flame being disrupted (e.g. by the wind), a Flame Safety Device will automatically shut off the

gas supply within 90 seconds.

Note: it is possible to light the appliance using a long match by lighting the burner through a hole in the guard mesh.

RE-LIGHTING

• Turn the Dial to the OFF position.

• Wait at least 2 minutes, to let gas dissipate, before attempting to re-light pilot.

• Repeat the “Lighting” steps.

TO EXTINGUISH

• Hold the dial down and turn clockwise to the OFF position

• Turn off the valve on the gas cylinder or the regulator after use.

• Disconnect the gas bottle and allow this appliance to cool before moving the appliance.

Note: After use, some discoloration of the emitter screen is normal. Turn off the regulator after use and allow

the appliance to cool before moving.