USER MANUAL OUTDOOR WALL AND CEILING HANGING HEATER eiQSTAR Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference.
Visit our page www.electriQ.co.
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating this unit. This appliance is for outdoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with the regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician.
• This unit contains no user-serviceable parts. • Always unplug or disconnect the appliance from the mains power supply when not in use, or when moving or cleaning it. Do not pull the cord to unplug the heater. • Keep the heater clean. Do not allow any object to enter the ventilation or exhaust opening as this may cause electric shock, fire, or damage to the heater. • Do not use the appliance for anything other than its intended use.
PARTS LIST PARTS PART NO. PART NAME 1 L shape bracket 2 3 4 M6mm*60mm screw M6mm screw M6mm*12mm screw QT Y 4 4 2 2 ASSEMBLY Tools Needed: Pencil Hammer Spirit Level Screw Driver Drill A wall mounting bracket is provide with the heater which has been specifically designed to allow this product to be fitted to a ceiling or wall. Before any drilling or installation commences, ensure that the wall or ceiling you are using for installation is free from wires and pipes.
WALL MOUNTED INSTALLATION CEILING MOUNTED INSTALLATION 6
CORRECT WALL AND CEILING POSITION INSTALLATION WITH TRIPOD STAND-(optional) 7
OPERATION 1. Turn on the power, the product will be in standby mode, the display will show (- -); 2. Press the function button, then press the heat levels to start the unit’s operation: (L1-L2-L3-L4- standby - off) REMOTE CONTROL Inserting Batteries Insert 2 AAA type batteries into your remote control 1. Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with the instructions and polarity the batteries. 2.
TROUBLESHOOTING Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and may cause bodily harm. Issue No power Odour emission from unit Possible Reason Solution 1. Power cord is unconnected 1. Connect the power cord 2. There is no power from socket 2. Check socket is turned on 3. The power switch on the rear of the unit 3. Ensure the power switch on is turned off. the rear of the unit is in the on position 1. New unit.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.
