USER MANUAL COOKER HOOD eiQTMS60BL eiQTMS90BL eiQTMS60SS Thank you for choosing electriQ Please read this user manual before using this product and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY 3 VENTILATION 5 BEFORE USE 6 PRODUCT OVERVIEW 7 INSTALLATION 8 FILTERS 11 OPERATION 12 CLEANING AND MAINTENANCE 13 LIGHT BULB REPLACEMENT 14 TROUBLESHOOTING 15 TECHNICAL SPECIFICATION 16 SUPPORT 17 2
SAFETY PRECAUTIONS Whilst this product is compliant with all safety requirements, incorrect or inappropriate use can lead to both personal injury and potential damage to property. Please read the contents of this instruction booklet thoroughly before fitting or using this appliance. • The cooker hood must be installed in accordance with the installation instructions and all measurements followed. • All installation work must be carried out by a competent person or qualified electrician.
• The minimum distance between the surface of the hob and the lowest part of the hood should be at least 65cm. A distance of between 65cm and 75cm gives peak efficiency. • The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels. • When the hood is vented externally and used with appliances which burn fuel (e.g. gas, oil, wood) the area must be sufficiently ventilated to ensure safe operation.
OPTIONS FOR VENTILATION This hood can be set up for either external venting or recirculation of the air. The type of setup should be decided before commencing installation. EXTERNAL VENTING If you have an outlet to the outside, your cooker hood can be connected as shown in the diagram using any suitable extraction duct (enamel, aluminium, flexible pipe or inflammable material with an interior diameter of 150mm) can be used.
BEFORE USAGE Before usage, read all the instructions and make sure that the voltage (V) and the frequency (Hz) indicated on the identification plate (found inside the cooker hood) and all the data inside the appliance are exactly the same as the voltage and frequency in your home. Plug the power lead into the power socket (or if connecting directly to the mains via a switched spur, ensure the work is carried out by a competent, qualified person) and the cooker hood is then ready for use.
PRODUCT OVERVIEW - PARTS SUPPLIED Description Cooker hood Illustration Qty.
INSTALLATION 8
INSTALLATION Before installation, ensure you have not connected the appliance to the mains supply. 1. The base of the cooker hood should be placed at a distance of 70~80cm above the cooking plane for best performance. 2. Drill 3 holes to accommodate the wall bracket. Screw and tighten the wall bracket onto the wall with the screws (4mm x 30 mm) and wall plugs provided. 3. Hang the appliance onto the wall bracket hook and fix the appliance using the 2 screws (4mm x 30mm). 5.
7. The 2 x air flaps should be installed at this stage, as access is easier before the unit is wall mounted. On the top of the Hood Unit itself, where the air outlet vent is located, the 2 x flaps should be carefully installed, bending very slightly so the lugs at each end locate into the holes, enabling flaps to pivot upwards when the unit is in operation, opening up the outlet fully for the air to pass through.
CARBON FILTER (Available separately) Activated carbon filters can be used to trap odors, and must be used if the hood is not vented to the outside. They are available from the same stockist you purchased the hood from under the following reference: eIQTMCARBONCHIM (Carbon Filter Pack of 2) In order to install the activated carbon filter, the metallic anti-grease filter should first be detached. Press the lock and pull it downward.
OPERATION Operation of your hood is extremely simple. There are essentially 3 controls: Power On/Off; Fan Speeds (3 separate buttons) and Illumination. Push buttons Off button Used for turning off the fan. Low Speed button Starts the fan in low speed mode. It is suitable for simmering and cooking which do not make much steam. Medium Speed button Starts the fan at medium speed. This is ideal for ventilation during standard cooking operation. High Speed button Starts the fan in high speed.
MAINTENANCE Before cleaning, switch the unit off and pull out the plug, or switch off at the relevant mains switch if the unit has been hard-wired. Make sure the unit has no power being fed to it. REGULAR CLEANING Use a soft cloth moistened with hand-warm mildly soapy water or household cleaning detergent. Never use metal pads, chemicals, abrasive material or a stiff brush to clean the unit.
LIGHT BULB REPLACEMENT Your cooker hood is supplied with 4 long life LED light fittings, although these are designed to have a very long lifespan, should one fail, replacements are available from the supplier of the hood and the guide below can be followed to replace it. 1. 2. 3. 4. 5. 6. Switch the unit off and make sure it is disconnected from the mains supply. Remove the aluminum grease filter Pull out the LED light carefully, follow the wire from the fitting, and unplug at the connector.
TROUBLESHOOTING Fault Cause Solution The fan blade is jammed. Light on, but fan does not work The motor is damaged. Switch off the unit. Repair to be carried out by qualified service personnel only. Both light and fan do not work Replace the bulb with correct rating. Halogen light bulb blown Power cord loose The fan blade is damaged. Excessive Vibration Suction performance not good The fan motor is not fixed tightly. Plug in to the power supply again. Switch off the unit.
SPECIFICATION Symbol Unit eiQTMS60BL eiQTMS90BL eiQTMS60SS Model identification Annual Energy Consumption Value AEChood 37.7 f 1.7 FDEhood 8.27 EEIhood 77.9 QBEP 155.78 m3/h Measured air pressure at best efficiency point PBEP 109.32 Pa Maximum airflow Qmax 320 m3/h W BEP 57.21 W WL 3 W Emiddle 148.2 lux PS -- W PO 0 W LWA 60.
INFORMATION FOR DISMANTLING Do not dismantle the appliance in a way which is not shown in the user manual. The appliance could not be dismantled by user. At the end of life, the appliance should not be disposed of with household waste. Check with your Local Authority or retailer for recycling advice. INFORMATION FOR DISMANTLING Do not dismantle the appliance in any way which is not shown in the user manual. The appliance must not be dismantled by an unqualified person.