User Manual

12
REPLACING THE BULB
1. Switch off the extractor
hood and ensure it is also
switched off at the mains
supply.
2. Remove the grease filter.
3. Unclip the lamp holder
using the spring clip on the
rear of the holder.
4. Disconnect the wiring connector on
the lead running from the lamp
holder.
5. Replace the holder and lamp with
identical unit available from the
retailer/manufacturer.
6. Remember to switch on at the mains once installation is
completed and the hood has been fully reassembled.
Information
Clean ventilation fans frequently. Grease should not be allowed to
accumulate on fan or filter.
INSTALLING THE OPTIONAL CARBON FILTER:
1. Remove the grease filter
2. The carbon filter is located
at the end of the motor. To
fit, rotate the filter
clockwise onto the motor
housing; to remove, rotate
filter anti-clockwise until it
is unscrewed.
Warning: the carbon filter cannot be washed or recycled. It should
be replaced after approximately 2-3 months of use.
Note: The optional carbon filter is available from the hood
supplier/manufacturer under stock code: eiQVISTMCARBON