User Manual

9
CUPBOARD MOUNTING INSTALLATION:
1. Drill a 130mm diameter and four 6mm diameter holes as shown in the
diagram.
NOTE: If your cooker hood is to be used in recirculating air mode or is
configured for rear venting, it is not necessary to cut the 130mm
diameter hole.
2. Attach the one way valve and then
use 4 screws to fix the cooker hood
to the underside of the kitchen
cupboard. Check that your fixings
are correctly located, by temporarily
fitting the cooker hood. If correct, fit
the unit into position. Tighten the
screws as necessary.