USER MANUAL ULTRASLIM 800 WATT OIL FILLED RADIATOR EORW800LED Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.uk for our entire product range THIS PRODUCT IS ONLY SUITABLE FOR WELL INSULATED SPACES OR OCCASIONAL USE.
CONTENTS SAFETY 3 PRODUCT OVERVIEW 5 OPERATION 5 TECHNICAL SPECIFICATIONS 7 CLEANING AND MAINTENANCE 8 TROUBLESHOOTING 8 PRODUCT FICHE 9 2
SAFETY INSTRUCTIONS IMPORTANT • Carefully read the instructions before operating the unit • This appliance is for indoor use only. • Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. • Installation must be in accordance with regulations of the country where the unit is used. • If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. • This heater has been tested and is safe to use.
• Never use the plug as a switch to start and turn off the heater. Use the provided power button located on the control panel. • Do not use an external timer. • Do not cover the appliance, or place items close to the unit which may restrict airflow, as this may present a fire risk. • The heater must not be located immediately below a socket outlet. • Always place the unit on a dry and stable surface. Do not move or tilt the unit. • Avoid keeping the unit in direct sunlight for a long period of time.
PRODUCT OVERVIEW Display W WE P3 25⁰C :-- ST OFF Temperature Up + Mode Selection Mode ON/OFF F Temperature Down Set Temperature Set - OPERATION Press the ON/OFF button to start the heater. To adjust the desired temperature, press the SET button and then adjust using the + and – buttons.
CHILD LOCK Press ”+” and ”–” at the same time to enable child lock. In child lock mode the control panel is deactivated. To exit child lock mode, press ”+” and ”–” again at the same time. OPEN WINDOW FUNCTION Press “ MODE” for 3 seconds, a buzzer will sound and the open window will be displayed . symbol Press “MODE” for 3 seconds to deactivate the feature. When this function is activated , the heater will stop working when the room temperature drops by 3℃ in 1 minute.
P2 TIMER: Is preset and cannot be adjusted. The heater will has different settings for weekdays and weekends. (Monday - Friday) Pre set program (Saturday - Sunday) Pre set program P3：Monday-Sunday Can be customised. 18-22℃ • Press the MODE button 3 times and set the day using the + and – buttons. • Press the MODE button 4 times and set the hour using the + and – buttons. • Press the MODE button 5 times and set the minute using the + and – buttons.
MAINTENANCE CLEANING AND STORAGE ATTENTION: Please shut off the unit and unplug from the mains before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the heater with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or gaps in the casing. • Do not run the unit until completely dry.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0871 620 1057 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.
Model Identifier: EORW800LED Item Symbol Value Unit Heat Output Item Unit Type of heat input, for electric storage local space heaters only (select one) Nominal heat output Pnom 0.8 kW manual heat charge control, with integrated thermostat No Minimal heat output Pmin 0.0 kW manual heat charge control with room and/or outdoor temperature feedback No Maximum continuous heat output Pmax 0.
