USER MANUAL ULTRASLIM 800 WATT WALL MOUNTABLE OIL FILLED RADIATOR EORW800LED Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY 3 PRODUCT OVERVIEW 5 ASSEMBLY/INSTALLATION 5 OPERATION 8 TECHNICAL SPECIFICATIONS 9 CLEANING, MAINTENANCE AND STORAGE 10 TROUBLESHOOTING 10 SUPPORT 11 PRODUCT FICHE 12 2
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating the unit. This appliance is for indoor use only. Rating: This unit must be only connected to a 220-240 V, 50/60 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician.
• Do not cover the appliance, or place items close to the unit which may restrict airflow, as this may present a fire risk. • The heater must not be located immediately below a socket outlet. • Always place the unit on a dry and stable surface. Do not move or tilt the unit. • Avoid keeping the unit in direct sunlight for a long period of time. • The heater is designed to be used at temperatures above -20°C.
KEY FEATURES • • • • • • • Can be wall mounted or free standing. Electronic control panel with thermostatic controls. Low energy consumption – only 800W. Open window detection to help prevent energy wastage. IP22 rated, great for any room. 7 Day timer. Ultra slim design - Only 6cm thick. PRODUCT OVERVIEW Power Switch Display Control Panel Temperature Sensor ASSEMBLY / INSTALLATION Your electriQ heater comes with both a bracket for wall mounting and a pair of feet for freestanding operation.
WALL MOUNTED INSTALLATION Before starting installation, ensure that there is no pipework or wiring in the wall behind the planned installation location. For wall mounted installation, you will need: 1. Spirit level 2. 4 screws (Supplied) 3. 4 wall plugs (Supplied) 4. Drill 5. Pencil 6. Tape measure Take one of the two mounting bars and hold it in position on the wall approx. 20cm in from the left-hand edge of the planned position of the heater.
Child Lock CONTROL PANEL Heating 24h Timer 7 Day Timer Standby Display Desired Temperature Current Room Temperature Day of Week Time Temperature Up Mode Selection Mode Temperature Down ON/OFF F Temperature Set Set ON/OFF Button (Standby) STATUS DISPLAY OFF The unit is in standby and the heating is turned off. ☼ The heater is operating. W The 7-day timer is set and operational. The 24-hour standby timer has been activated, and the unit will enter standby when the timer elapses.
OPERATION Press the ON/OFF button to start the heater. To adjust the desired temperature, press the SET button and then adjust using the + and – buttons. SETTING THE DAY AND TIME • When the heater is operating and the timers are off, press the SET button 3 times so that the day is flashing and use the + and – buttons to adjust. • Then press the SET button once so that the hour is flashing and use the + and – buttons to adjust.
7-DAY TIMER Press “MODE” button to enter the 7-day timer mode then choose between the pre-sets: P1, P2, P3, P4 using the + and - buttons. ：Comfort mode is 22℃. ：ECO mode is 18 ℃. P1 TIMER: (Monday - Sunday) is a Pre-set program and no adjustment is possible P2 TIMER: Is preset and cannot be adjusted. The heater will has different settings for weekdays and weekends. (Monday - Friday) Pre-set program (Saturday - Sunday) Pre-set program P3 TIMER: (Monday-Sunday) Can be customised between 5℃ and 45℃.
P4：ANTI-FROST “P4 Fr” will be displayed on screen and the heater will aim to keep the temperature between 4°C and 7°C. CLEANING, MAINTENANCE AND STORAGE ATTENTION: Please shut off the unit and unplug from the mains before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the heater with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or gaps in the casing.
TECHNICAL SPECIFICATIONS Model no. Voltage Frequency Max power IP Rating Product Dimensions EORW800LED 220-240V 50/60hz 800W IP22 950x65x550mm electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved.
Model Identifier: EORW800LED Item Symbol Value Unit Heat Output Item Unit Type of heat input, for electric storage local space heaters only (select one) Nominal heat output Pnom 0.8 kW manual heat charge control, with integrated thermostat No Minimal heat output Pmin 0.0 kW manual heat charge control with room and/or outdoor temperature feedback No Maximum continuous heat output Pmax 0.
