User Manual

4
• Do not cover the appliance, or place items close to the unit which may restrict
airflow, as this may present a fire risk.
• The heater must not be located immediately below a socket outlet.
• Always place the unit on a dry and stable surface. Do not move or tilt the unit.
• Avoid keeping the unit in direct sunlight for a long period of time.
• The heater is designed to be used at temperatures above -20°C. If it is exposed to
temperatures below this, it must be allowed to warm above this level before
operation.
• Do not attempt to repair, disassemble or modify the appliance. This unit contains no
user-serviceable parts.
• Always unplug or disconnect the appliance from the mains power supply when not
in use, or when moving or cleaning it. Do not pull the cord to unplug the heater.
• Keep the heater clean. Do not allow any object to enter the ventilation or exhaust
opening as this may cause electric shock, fire, or damage to the heater.
• Do not use the appliance for anything other than its intended use. It is designed for
domestic indoor use only.
• There may be a trace of odour during the first few minutes of initial use, or after a
period of storage. This is normal and will quickly disappear.
• This appliance has hot and arcing or sparking parts inside. Do not use it in areas
where gasoline, paint, or any flammable liquids are used or stored.
• This appliance is IP22 rated, and so can be used or installed within a bathroom as long
as the appliance and its cables are not within Zones 0-2.
• If used within a bathroom, the circuit must be protected by a suitable RCD to prevent
electric shock.
• Do not allow the appliance to be submerged or sprayed with water.
• Never locate this appliance where it may fall into a bathtub or otherwise become
exposed to water.
• If the unit is wall-mounted, it must be installed in accordance with current regulations
for the area of installation. If unsure, professional advice should be sought.
• WARNING: To reduce the risk of fire or electrical shock, DO NOT use this appliance
with any solid-state Speed Control Device or any variable speed controllers.
• The heater must be wall mounted, or the feet attached before plugging into the
mains.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS
• Do not cover or restrict the airflow.
• Do not use in dusty environment.
• Unplug the unit when not in use.