User Manual

6
WALL MOUNTED INSTALLATION
Before starting installation, ensure that there is no pipework or wiring in the wall behind the
planned installation location.
For wall mounted installation, you will need:
1. Spirit level
2. 4 screws (Supplied)
3. 4 wall plugs (Supplied)
4. Drill
5. Pencil
6. Tape measure
Take one of the two mounting bars and hold it in position on the wall approx. 20cm in from
the left-hand edge of the planned position of the heater. Mark the wall with a pencil
through the top mounting hole to indicate the position of the first screw hole. Then place
another mark 50cm to the right of the initial mark, using a spirit level to ensure they are
straight.
Drill the wall in the positions marked, and loosely fit the brackets using the supplied wall
plugs and screws. Depending on the type of wall alternative fittings may be required.
Use a spirit level to ensure the brackets are straight, before marking the position of the
lower security holes on the wall. Remove the brackets and drill the wall in the two positions
marked. Slide the remaining 2 wall plugs into the holes, before fully securing the brackets to
the wall using the supplied screws.
Once this is complete, carefully slide the base of the heater onto the bottom of the
mounting bar, before sliding the top of the brackets up and clipping the top of the heater in
position. Ensure that the heater is fully secure on the wall, before connecting the power.
Height Adjustment
Spring
Mounting
Holes
Security
Holes