USER MANUAL OUTDOOR FLOOR STANDING AND WALL HANGING HEATER EQODETALL Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 PARTS LIST 5 ASSEMBLY 5 INSTALLATION 6 OPERATION 7 TROUBLESHOOTING 7 CLEANING AND MAINTENANCE 8 TECHNICAL SPECIFICATIONS 8 SUPPORT 9 2
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating this unit. This appliance is for outdoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with the regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician.
• • • • • • • • • • • • • • • • • • or when moving or cleaning it. Do not pull the cord to unplug the heater. Keep the heater clean. Do not allow any object to enter the ventilation or exhaust opening as this may cause electric shock, fire, or damage to the heater. Do not use the appliance for anything other than its intended use. There may be a trace of odour during the first few minutes of initial use, or after a period of storage. This is normal and will quickly disappear.
PARTS LIST PART NUMBER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 DESCRIPTION Heater Control dial Main body Position indication plate Pull switch Clips Upper pole Clamp 1 M6x6 bolt Middle pole Power cord Clamp 1 M6x6 bolt Base pole Base cover 4 M6x30 bolts Base 5
INSTALLATION Check all the parts against the parts list. If parts are missing, please contact the supplier using the information located on page KIHHIPHPIJHPI This product MUST NOT be used if the power cable is damaged. For ease of assembly only loosely tighten bolts and tighten fully when assembly is complete. WARNING: Do not over tighten bolts; only tighten with moderate pressure to avoid damaging the bolts or components of the heater. STANDING INSTALLATION 1.
OPERATION 1. Before plugging the heater into a power supply, please first adjust the height and angle of the heater. 2. To adjust the height of your heater, turn the plastic adjustment fixing anticlockwise to unlock it. Lift up the heater to the desired height then turn the plastic adjustment fixing clockwise to secure the height of your heater. 3. You can change the angle of your heater by up to 45⁰. You can adjust this by gently moving the heater to your desired angle.
CLEANING AND MAINTENANCE ATTENTION: Please turn off the unit and unplug from the mains and allow to fully cool before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the heater with a duster or a soft wet cloth. • Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or gaps in the casing. • Do not run the unit until completely dry.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.
