User Manual

OPERATION

1. Before plugging the heater into a power supply, please first adjust the height and

angle of the heater.

2. To adjust the height of your heater, turn the plastic adjustment fixing anticlockwise

to unlock it. Lift up the heater to the desired height then turn the plastic adjustment

fixing clockwise to secure the height of your heater.

3. You can change the angle of your heater by up to 45⁰. You can adjust this by

gently moving the heater to your desired angle. Only change the angle of your

heater when it is not in use and it is completely cool.

1. Plug the unit into a plug socket, make sure the power supply is the same as rated.

2. Pull down on the switch cord to turn the unit on.

To control the heat output of the unit, use the dial located on the heater.

TROUBLESHOOTING

Do not repair or disassemble the unit by yourself, unauthorized repair attempts will

invalidate the warranty and may cause bodily harm.

Issue

Possible Reason

Solution

No power

1. Power cord is unconnected

2. There is no power from socket

3. The power switch on the rear of the unit

is turned off.

1. Connect the power cord

2. Check socket is turned on

3. Ensure the power switch on

the rear of the unit is in the on

position

Odour

emission

from unit

1. New unit. When the unit is used for the

first time the heater may produce and odour

which will dissipate within a week of use

1. No action required

If the unit fails, turn the heater off at the main switch and tilt the head up as far as possible

and then bring back to facing forward and tighten. Once complete try switching on again.

Value

Function

OFF

Low heat

Medium heat

High heat