User Manual

7
ANCHORING TO THE GROUND
The patio heater can be fastened to solid ground such as a concrete block for security
and safety.
STEP 1
Place the product in the desired location (concrete surface
recommended) in accordance with the safety regulations and user
guidelines. Mark 3 points on the ground around the heater as per
diagram A. Remove the product to proceed to the drilling step.
STEP 2
Using an appropriate drill bit, drill a hole on each point as marked
from step one (Expansion bolt is 6mm in diameter).
STEP 3
Place the product back in the desired location and overlay the fixing
clips (6) align with the previously drilled holes as shown in diagram B.
STEP 4
Tap the expansion bolts (B) into holes and fasten each bolt using a
spanner to secure in place.
Diagram B