USER MANUAL OUTDOOR AND INDOOR FLOOR STANDING HEATER EQODETTM Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 PARTS LIST 5 ASSEMBLY 5 OPERATION 6 TROUBLESHOOTING 6 CLEANING AND MAINTENANCE 6 TECHNICAL SPECIFICATIONS 7 SUPPORT 7 2
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating this unit. This appliance is for outdoor and indoor use. Rating: This unit must be only connected to a 220-240 V / 50-60 Hz earthed outlet. Installation must be in accordance with the regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician.
• Keep the heater clean. Do not allow any object to enter the ventilation or exhaust opening as this may cause electric shock, fire, or damage to the heater. • Do not use the appliance for anything other than its intended use. • There may be a trace of odour during the first few minutes of initial use, or after a period of storage. This is normal and will quickly disappear. • This appliance has hot and arcing or sparking parts inside.
PARTS LIST A PARTS PART NAME Heater Head B C D E F Stem Base Bolts Cable Cable clip PART NO. QTY 1 1 1 2 1 1 ASSEMBLY Step 1: Screw the stem clockwise into the base Step 2: Through the hole in the centre of the base, carefully feed the cable through the stem from the base until the cable is visible at the top of the stem. Step 3: Connect the cable to heater head. Then use the cable clip to fix the connection. The arrow on the clip should point towards the heater head.
OPERATION Button Function For 750W heat For 1500W heat Heater is powered off TROUBLESHOOTING Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and may cause bodily harm. Issue No power Odour emission from unit Possible Reason Solution 1. Power cord is unconnected 1. Connect the power cord 2. There is no power from socket 2. Check socket is turned on 3. The power switch on the rear of the unit 3. Ensure the power switch on is turned off.
TECHNICAL SPECIFICATIONS Model Voltage(V) Wattage(W) EQODETTM 220-240V AC 1500W Hertz (Hz) 50-60 Dimensions W×H×D(mm) 470*350*470mm Weight (KG) 5.1kg IP Rating IP55 Height 81cm electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3.
