User Manual

STEP 5: Attach Flame Screen (2) to the top of Support Bar-Upper (3) and fix the connection with 2pcs M5 screws

and washers (BB), (See FigureⅠ, Ⅱ).

Repeat this step and connect Flame Screen (2) to other 3 sets Support Bars-Upper (3). (See Figure Ⅲ, Ⅳ)

STEP 6: Place Reflector (1) on the Flame Screen (2)

and fix the connection with 4pcs M5 CAP NUT (AA).

STEP 7: Place the whole upper parts to top of tank housing assembly. Make

sure match the top ends of tank housing assembly with the bottom slot of

Support Bar – Upper (3). Match the threaded holes and fix each connection with

2pcs M5 Screws and Washers (BB)