Instruction Manual

Page 6 of 24
INSTALLATION OF HEATING ELEMENT
IMPORTANT: Before drilling, ensure that no wires or pipelines are behind the wall to prevent
damage.
IMPORTANT: This heater is heavy. Two people are recommended for installation.
Your new heater comes with 2 heating elements for separate heating. These two elements
can work independently of eachother. To link both elements and have them work as one
unit, please see page 15. First ensure that you have all the correct parts needed for
installation of the heating element:
• Heating Element x2
• PTFE Tape
• Spanner
• The heating element is designed to be fitted into the bottom of the unit and can be
fitted into either the left or right port. Before installing, decide on the location where
your heater will be mounted, take care to ensure that the element will be accessible and
that the power cord can reach a suitable socket when your heater is mounted to the
wall.
• Wrap the provided PTFE tape around the thread of the heating element, ensuring the
full thread is covered.
• Then carefully turn the heater on its side with the port you have chosen for installation
facing upwards. This allows for easy installation of the element and prevents the
possible leakage of Glycol.
• Remove the locking nut from the port using the provided spanner and keep safe for
future installation.
• Gently insert the element into the port and screw into place. Ensure that the control panel
is facing the front of the unit before installing onto the wall.
Repeat the above steps for fitting the second heating element.
Thread