Instruction Manual

Page 4 of 24
• Do not use the appliance for anything other than its intended use. It is designed for domestic
indoor use only.
• There may be a trace of odour during the first few minutes of initial use, or after a period of
storage. This is normal and will quickly disappear.
• This appliance has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint, or any flammable liquids are used or stored.
• Never locate this appliance where it may fall into a bathtub or otherwise become exposed to
water.
• This appliance is IPX4 rated, and so can be used or installed within a bathroom as long as the
appliance and its cables are not within Zones 0-2.
• If used within a bathroom, the circuit must be protected by a suitable RCD to prevent electric
shock.
• Do not allow the appliance to be submerged or sprayed with water.
• The unit must be installed in accordance with current regulations for the area of installation.
If unsure, professional advice should be sought.
• WARNING: To reduce the risk of fire or electrical shock, DO NOT use this appliance with any
solid-state Speed Control Device or any variable speed controllers.
• Installation must be in accordance with all relevant local regulations applicable at the time
of installation.
• If electrical work is carried out within the bathroom which involves addition or alteration of
existing circuits, it may be notifiable to your local building control department (Part P). If
unsure, professional advice should be sought.
• Ensure that your heater is filled with Glycol. If filling up your heater with Glycol, ensure to
leave room inside the unit for expansion. It is recommended to leave 10 percent of the unit
empty.
• Illustrations in this manual may differ from the final product, this is due to constant product
development and improvement.
PARTS SUPPLIED
HEATER
SCREWS (B) X8
WALL PLUGS X8
UPPER AND LOWER
BRACKET X4
PTFE TAPE X1
SPANNER X1
BRACKET COVER X1
HEATING ELEMENT X2