Instruction Manual

nylon brush. Rinse and dry thoroughly.
Discoloration of the plastic parts may occur with brightly colored fruit and vegetables. To help
prevent this, wash parts immediately after use. If discoloration does occur, the plastic parts can
be soaked in 10% lemon juice and water or they can be cleaned with a nonabrasive cleaner.
When not in use store your appliance and all its accessories and instruction manual in a safe
and dry place.
Note: Optional accessories can be cleaned following the same procedure.
Technical Specification
Voltage: 220-240V~
Frequency: 50/60Hz
Power Input: 150W
Speed: 80 RPM
Troubleshooting
Fault Cause Troubleshooting
Not starting
Improper installation. Reinstall the appliance following
assembly instructions
Burnt smell coming
from unit
Normal for first time use. Should
disappear over the time.
Return the appliance to retailer for
repair or exchange if unpleasant smell
persists after repeated use.
The motor appears
to struggle/cut out
during use.
Too much food being juiced at once.
Food is clogging the juicing auger.
Feed food into the feeder slower and
use smaller size pieces.
Turn the slow juicer to the off position
and wait until juicer stops. Select the
‘Reverse’ position on the control
switch until blockage is cleared.
Stopping during
use
Excessive ingredients blocking the
juicing blade
The pusher is forced down
Motor thermal control protection
Disconnect power, remove the surplus
then reassemble.
Use less force on pusher
Restart after pausing 20-30 minutes.
The pulp appears
to be very wet.
Large amounts of fibrous fruit and
vegetables have caused excess pulp to
build up in the juicing screen.
Stop
juicing. Disassem
ble slow juicer
and clean the juicing screen using the
cleaning brush provided. See
Disassembly and Cleaning section.
When resume juicing feed food slowly
into the feeder.
22