Instruction Manual

• Cleaning cloth is too wet

• Glass is already very clean and slippery

• Humidity is too low

• Solution: use program , , or putting the machine in the middle of the

window to avoid malfunction

5. Uneven operation of the machine

• Cleaning cloth is too dirty. Replace cloth with clean one.

• Uneven areas on the surface of the glass, for example algae.

• Cleaning wheel loose, please tighten.

6. Due to a power outage, the machine makes warning sound and red light flashes

• Robot is using backup battery. To prevent complete power failure, use the

safety harness to pull it back to a safe position. Turn off the power and check

all power connections.

7. The machine encounters an obstacle and stops with the red light flashing (no

warning sound).

• Use the safety harness to pull the unit back to a safe position.

• Eliminate obstacles on windows

• Check if there is a cause of leakage

8. On start-up, the machine does not operate, with no alarm.

Scenario

LED status

Machine status

Right LED: off

Battery voltage is too low, please charge to full power (green LED) and

then use. If after charging for more than 8 hours the situation is the

same, battery has failed and needs replacing

Central LED: Blue

flashing

Alarm

Left LED: Red

flashing

Hardware failure

Please contact customer services for repair.

Central LED: Blue

flashing

No alarm

9. After cleaning the windows, swirls are visible on the glass at night.

• Repeat cleaning with a dry cloth. Then clean and dry the cleaning wheel.

• Fit a new cleaning cloth and dampen with one to two drops of cleaning agent

or alcohol. This will remove swirl marks.

10. The machine has cleaned the whole window and does not stop automatically.

• Press the stop button on the remote control.