Instruction Manual

9
DIAGNOSTICS
The functional status of the robot can be read from its status indicator window. There are
three LEDs, one in the left of the window, one in the centre and one on the right.
Left
LED
Centre
LED
Right
LED
STATUS
Red
Charging
Green
Fully charged
Red
flashing
Warning
sound
Power supply interrupted
Red
flashing
Blue
flashing
Hardware error
Red
flashing
Beep
Vacuum too low / air
leakage during operation
CLEANING AND MAINTENANCE
After use, please wash the cleaning cloths as follows:
• Washing temperature lower than 40°C
• Do not tumble dry
• Do not iron
• Not dry clean
• Do not bleach
TROUBLESHOOTING
1. On start-up, the machine performs a self-test, if any problems are detected, such
as too little or too much friction please check the following:
• Is the cleaning cloth too dirty?
• Glass is unsuitable?
• Glass is already very clean and too slippery to clean again?
• Humidity too low, glass too slippery?
2. Using the automatic program the machine slips and cannot detect the edge
of the window.
• Stop the device and use alternative programs or
3. The machine does not complete the cleaning of the window and stops before
completing the window.
• Use program and to continue the unfinished parts
4. The unit skids and cannot climb the window
• Friction is too low, suction from the fan is too low