User Manual

Once the chains are fitted and secure, any excess chain should be

removed by cutting the chain.

We would also advise running a bead of exterior caulk or similar

around the external vent to help prevent water ingress.

Lift the unit onto the wall, align the hanging holes with the

hooks on the hanging rail and gently rest the unit into place.

At the same time, slide the drain pipe through the drainage

hole. If the wireless controller (Available separately) has

been purchased, it should then be installed, and connected.

NOTE: The end of the external water pipe must be placed in

an open space or drain. Avoid damage or constriction to the

drainage pipe to ensure the unit drains.

Place the bracket in position on the

under side of the unit and mark the

position of the screw hole on the wall.

Remove the bracket and drill a hole

using a 8mm drill bit before inserting a

wall plug.

Fix the bracket into position on the

underside of the unit using the 2 small

screws. Then attach the bracket to the

wall using a screw through the wall plug

previously inserted.