USER MANUAL WIRED CONTROLLER IQOOLSMART12HP-WiredCtrl Suitable for IQOOL-SMART12HP and IQOOL-SMART15HP air conditioners Read these instructions carefully and keep them safe for future reference.
SAFETY WARNINGS • • • • • • • • • • • • • • • • • Before attempting installation, the Installation Manual must be fully read and understood. This controller is compatible with the IQOOL-SMART12HP and IQOOL-SMART15HP air conditioners. When choosing a suitable position for installation, consideration should be made to avoid external influences which may damage the unit, shorten its life, or make the unit unsafe. Places to avoid include: 1. Areas in the vicinity of flammable gasses. 2.
INSTALLATION Remove the wired controller from the backing plate using a flat headed screwdriver in the gap between the backing plate and the controller. Once the two parts are separated, the remainder can be unclipped. Pass the signal wire through the opening in the rear of the backing plate, ensuring it is positioned so it will not be trapped or damaged during installation. Allow enough cable to pass through for ease of installation and future maintenance.
CONTROL PANEL Power Standard wire controller Timer Mode selection Clock Fan speed Enter Silent mode Time Temperature Swing DISPLAY Dehumidify Mode Cooling Mode Error indicator Heating Mode Fan Mode Desired Temperature Room Temperature Timer display Clock Swing Silent Fan Speed 4
OPERATION POWER BUTTON: Press to turn the air conditioner ON and OFF MODE BUTTON: While the air conditioner is operating press the mode button to change between the 4 modes. The current mode will be shown on the display. Heating Mode Dehumidify Mode Fan Mode Cooling Mode TEMP AND BUTTONS These buttons are used to increase or decrease the desired room temperature. Both the current temperature and the desired temperature are shown on the display.
DISASSEMBLY Disassembly is the reverse of installation. Make sure that the mains power has been disconnected to avoid risk of injury. Remove the wired controller from the backing plate using a flat head screwdriver in the gap between the backing plate and the controller. Once the two parts are separated, the remainder can be unclipped. Disconnect the signal wires from the rear of the wired controller.
