User manual

Page 13 of 16
Maintenance
Cleaning.
Please shut off the unit and unplug from the mains before cleaning or performing
any maintenance
Clean the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage.
Air filter cleaning
a) Clean the air filters every 2 weeks. If the air filter is blocked with dust, the unit’s
performance will be significantly affected.
b) Pull out the top and bottom filters as pictured below
c) Wash the air filters by immersing them in warm (about 40℃) water with a neutral
detergent.
d) Rinse it and then dry it thoroughly.
e) Carefully re-install air filters
Open from here
Please note: The active carbon filter (cloth) should be changed every 2-3 weeks based on
the environment.
End of Season Maintenance：
：：
：
1. Pull out the plug from the drainage hole and empty the internal tank. You can also
drain the water by leaning the unit.
2. Then switch the unit to Fan mode, and hold the button down for 5 seconds until it
reaches a low fan speed.
3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to
keep the inside of the unit dry and prevents mold developing
4. Turn off the unit and pull out the plug.
5. Coil the wire and bind it together, then put it into the accessories space.
6. Separate the air-exhausted pipe and store it safely.
7. Cover the unit and keep it in a dry place.
8. Take the batteries out of remote control and store, or dispose, them safely
* All accessories can be put in the accessories space at the back of the unit .