User Manual

6
OPERATION
SPEED CONTROL
Twist the SWITCH CONTROL to select the desired speed, between off, low, medium and
high,
OSCILLATION
Push down the OSCILLATION KNOB to start oscillation. Pull it up to stop oscillation.
FAN ANGLE
Loosen the TILT ADJUSTMENT KNOB slightly to adjust the tilt angle of the fan head, then
re-tighten.
HEIGHT ADJUSTMENT
To adjust the height, loosen the HEIGHT-ADJUST KNOB, lift or lower Inner Pole to the
desired height, and retighten
MAINTENANCE
ATTENTION: Please shut off the unit and unplug from the mains before
cleaning or performing any maintenance.
CLEANING THE SURFACE
Clean the grills with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or fan motor
Do not run the unit until completely dry.
Place the fan in its original box or cover the fan to protect it from dust.
Store it in a cool dry place.
TROUBLESHOOTING
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate
the warranty and may cause bodily harm.
Issue
Possible Reason
Solution
No power
1. Power cord is unconnected
2. The There is no power from
socket
3. The power switch is not on.
4. The fuse has blown
1. Connect the power cord
2. Check socket is turned on
3. Turn the unit on
4. Replace the fuse in the plug
Strong vibrations
and noise
1. Fan is not used on a flat surface
2. Fan may be damaged
1. Place on a flat surface. May put
an anti-vibration matt underneath
2. if fan is damaged discontinue
use and contact service centre
If the above solutions do not resolve the problem please contact the service centre.