USER MANUAL SLIM20I EVAPORATIVE COOLER Thank you for choosing electriQ Please read this user manual before using this innovative Air Cooler and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 FEATURES 4 HOW EVAPORATIVE AIR COOLERS WORK 5 DIAGRAM 6 INSTALLATION 6 CONTROL PANEL 7 OPERATION 7 REMOTE CONTROL 8 FILLING THE WATER TANK 8 MAINTENANCE 9 TROUBLE SHOOTING 11 APPENDIX 11 SPECIFICATION 12 SUPPORT 12 Page 2 of 12
SAFETY INSTRUCTIONS IMPORTANT! • • • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating the unit This appliance is for indoor use only. Any outdoor use must be supervised and the unit must not be exposed to wet conditions such as rain. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS • • • • • • • Do not cover or restrict the airflow from the outlet or inlet grills. For maximum performance the minimum distance from a wall or objects should be 50cm. Please make sure, while in operation, the water in the water tank does not exceed the MAX level and does not fall below MIN. Keep the filters clean. Under normal conditions, filters should only need cleaning once every three weeks (approximately).
HOW EVAPORATIVE AIR COOLERS WORK The air cooler cools the air by means of evaporation. When water evaporates into the air, the result is a mixture of air and water molecules. This chemical change requires heat which is taken from the water molecules, resulting in a spot cooling effect. • The recommended relative humidity for optimum operation is 60% or lower. A drier climate makes for more noticeable cooling. • The evaporative air cooler should not be used in enclosed or sealed spaces.
DIAGRAM Top Water Tank Control Panel Louvres (Air Outlet) Air Inlet Water Tank Castors INSTALLATION This unit can easily be moved from one room to another. While moving the unit please note that it must always be kept upright and then placed on an even surface. • • • • • • Remove any packaging - keeping the air cooler in a vertical position. Make sure all parts are present and the unit is assembled correctly Ensure the clasps attaching the Water tank are secure.
CONTROL PANEL OPERATION Press to turn the air cooler On / Off Press to change the fan speed between low, medium and high. The currently selected fan speed will be illuminated. Press to change between normal, natural and sleep: Normal: Fan operates at a constant level. Natural: The fan speed fluctuates to imitate a natural breeze. Sleep: The fan speed will decrease by 1 level every half hour and then remain at low. The relevant light will illuminate to indicate the mode currently selected.
REMOTE CONTROL The remote control enables you to control all the same functions as the control panel from a distance of upto 6 metres. The remote control should be pointed towards the receiver on the front of the air cooler. ATTENTION: • Do not mix old and new or different types of batteries • If not in use for a prolonged period the batteries should be removed. FILLING THE WATER TANK Before turning on the cooling function, please add water to the tank.
MAINTENANCE CLEANING ATTENTION: Please turn off the appliance and disconnect from the mains before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the plastic housing with a duster or a soft wet cloth. • Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. • Make sure no water enters the control panel.
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS Honeycomb Filter Filter Frame / Air Filter The appliance is supplied with a set of honeycomb cooling / filters pads. The cleaning frequency for the honeycomb filters depend on local air and water conditions. In areas where the mineral content of the water is high (hard water), mineral deposits may build up on the honeycomb filter and restrict air flow.
TROUBLESHOOTING Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and may cause bodily harm. Issue No power Possible Reason Solution 1. Power cord is not plugged in 1. Connect the power cord 2. No power from the socket. 2. Check socket is switched 3. Honeycomb filter support is not on – test with a different installed correctly appliance. 4. The power button has not been 3. Install the honeycomb filter pressed. correctly. 4.
TECHNICAL DATA Model Number: SLIM20I Description Symbol Value Unit 18 Litres 220-240 V Frequency 50 Hz Power 200 W Water Tank Voltage Maximum fan flow rate F 900.0 m3/min Fan Power input P 75 W Service Value SV 12 (m3/min)/W Standby Power Consumption PSB ≤0.5 W Fan sound power level LWA 55 dB(A) c 9 Meters/sec Maximum air velocity Size (LxWxH) 445 x 345 x 835 Net weight 10.