USER MANUAL TF29OSCT8RW 29 INCH TOWER FAN Thank you for choosing electriQ Please read this user manual before using this air circulator and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 FEATURES 5 DIAGRAM 5 INSTALLATION 6 OPERATION 6 CONTROL PANEL AND SETTINGS 6 REMOTE CONTROL 7 MAINTENANCE 8 TROUBLE SHOOTING 8 APPENDIX 9 Page 2 of 10
SAFETY INSTRUCTIONS Important! • Carefully read the instructions before operating the unit • This appliance is for indoor use only. • Rating: This unit must be only connected to a 220-240 V / 50-60 Hz earthed outlet. • Installation must be in accordance with regulations of the country where the unit is used. • If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. • This fan has been tested and is safe to use.
• • • • • provided ON/OFF switch located on the control panel. Always place the unit on a dry and stable surface. Do not move or tilt the unit High Velocity fans are designed to create rapid air movement, therefore make sure the fan is not placed near curtains or any objects that may be drawn into the fan inlet. The appliance should not be installed in laundry or wet rooms Do not use this unit in environments with flammable and explosive gases.
TF29OSCT8RW 29 Inch Tower Fan with 3 Speed Settings FEATURES ⚫ ⚫ ⚫ ⚫ ⚫ ⚫ Slim design takes minimal space High Speed Motor with 3 Fan Speed Settings Swing function 7.5-hour standby timer allows the operating time to be set in 30-minute intervals. Remote Control allowing all functions to be changed. Choice of modes allowing the operation of the unit to be adjusted to the environment.
INSTALLATION 1. Push the two parts of the base together ensuring that the power cable is fed through the center. 2. Line up the tower fan on the base and fix the 4 screws into position using a screwdriver 3. Press the power cable into the two clips in the underside of the base, so that it runs out of the rear of the base. OPERATION Once assembled your fan may be operated by using either the manual controls located on the top of the fan or by your remote control.
1. POWER BUTTON Used to turn the tower fan ON and OFF. 2. SPEED BUTTON Press to cycle through the three available fan speeds. Lo – Low Speed, M – Medium Speed, and Hi – High Speed. 3. MODE BUTTON Press to cycle through the modes. Standard Mode: The fan will operate normally Breeze Mode: The fan speed will vary to imitate a natural breeze. Sleep Mode: The fan speed will be decrease by a level every 30 minutes, and once on low will remain running at that speed. 4.
MAINTENANCE CLEANING AND STORAGE ATTENTION: Please shut off the unit and unplug from the mains before cleaning or performing any maintenance. Cleaning the surface Clean the grills with a duster or a soft wet cloth. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or fan motor Do not run the unit until completely dry. Place the fan in its original box or cover the fan to protect it from dust.
APPENDIX Disposal: Do not dispose this product as unsorted municipal waste. Collection of such waste must be handled separately as special treatment is necessary. Recycling facilities are now available for all customers at which you can deposit your old electrical products. Customers will be able to take any old electrical equipment to participating civic amenity sites run by their local councils.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.