Instruction Manual

6
ASSEMBLY INSTRUCTIONS
• The castors must be attached before the heater is operated.
• Castors are supplied with the device. You must mount them on the
supplied mounting plates and then attach these to the unit before
use.
WARNING: Do not operate without the castors. Only operate the
heater in an upright position.
POSITIONING THE HEATER
• Place the unit in an upright position on a flat, stable and heat-resistant surface.
• Ensure that there are no flammable or heat-sensitive materials or substances
within one metre of the front and 50 cm of the rear and sides of the unit.
• Do not cover the heater.
CONNECTING THE HEATER
• Before inserting the plug into a suitable socket, make sure that the unit is intact,
properly assembled and that there is no signs of damage to the appliance or its
power cable.
• To avoid overloading a circuit, connect the unit only to a circuit where no other
equipment is connected.
• When the power switch is in the OFF position, insert the plug into an earthed
socket and turn on the power.
DISPLAY SCREEN
LOW
MEDIUM
HIGH
TIMER
POWER
HEAT
LEVEL