User Manual

KILLSWITCH
MOMENTARY LINE SELECTOR
Congratulations on your purchase of the Electro-Harmonix KILLSWITCH.
– KILL SETUP –
– LINE SELECTOR SETUP –
In this setup, the KILLSWITCH allows you to
quickly switch between mute and unmute by
pressing the footswitch, resulting in a hard
rhythmic tremolo effect.
In this setup, the KILLSWITCH allows you to
quickly switch between an effects loop and your
dry signal by pressing the footswitch.
Depending on the effects in the loop, it could
trigger a burst of distortion, or perhaps a foot-
controlled delay feedback… the possibilities are
endless!
INPUT JACK – Connect to the output of your
instrument or another effects pedal
INPUT JACK – Connect to the output of your
instrument or another effects pedal
SEND JACK – Disconnect
SEND JACK – Connect to the input of your
effects loop
RETURN JACK – Disconnect
RETURN JACK – Connect to the output of your
effects loop
AMP JACK – Connect to the input of your
amplifier or another effects pedal
AMP JACK – Connect to the input of your
amplifier or another effects pedal
- LED INDICATOR –
In either setup, the LED reflects the signal present at the AMP jack.
LED OFF – The AMP jack outputs the original INPUT signal
LED ON – The AMP jack outputs the signal from the effects loop (or no signal, in Kill Setup)