User Manual

REVERSE Button – Press the REVERSE button to play the loop in reverse. The

REVERSE button glows red when enabled. Reverse can be used at any time to

playback or overdub a loop.

½ SPEED Button – Pressing the ½ SPEED button causes the pitch of the loop

to go down one octave and the tempo is halved. If a loop is overdubbed during

half-speed mode, returning to normal speed playback causes the pitch of the

overdub to go up one octave and the tempo is doubled. The ½ SPEED button

glows red when enabled. ½ SPEED can be used at any time during playback or

while overdubbing a loop.

FX LED – Indicates when an effect is active. The FX LED automatically lights

when the REVERSE or ½ SPEED buttons are used and the STOP/FX footswitch is

programmed to operate in STOP mode. Alternatively, the FX LED will toggle

on/off each time the STOP/FX footswitch is pressed and programmed to operate

in FX mode.

MONO/L INPUT – ¼” Left Instrument/Line Input Jack. Plug the output of your

instrument or another effects pedal into this jack. If you use just one input we

recommend you use the MONO/L input. The input impedance presented at this

jack is 1MΩ. The maximum allowable signal level into this jack is +6 dBu. The

input is unbalanced.

R INPUT – ¼” Right Input Jack. Plug the output of your instrument or another

effects pedal into this jack. Use this jack for stereo recording. The input

impedance presented at this jack is 1MΩ. The maximum allowable signal level

into this jack is +6 dBu; it is an unbalanced input.

MONO/L OUTPUT – ¼” Left Output Jack. The Left output signal is sent

through this jack. The dry signal present at the Left input will be output on the

MONO/L Output jack. The source impedance of the MONO/L Output is

approximately 330Ω.

Note: the MONO/L OUTPUT jack also functions as a power switch when

powered from a battery. Disconnect the cable to save battery power when the

720 is not in use.

R Output – ¼” Right Output Jack. The Right output signal is sent through this

jack. The dry signal present at the Right input jack is output to the R Output

jack. The source impedance of the R Output is 330Ω.