User Manual

20
REAR CONNECTIONS AND CONTROL
1. 9VDC 400mA Power Jack
Connect the output plug of the factory-supplied
AC Adapter into this 9VDC power jack. The
current requirement is 400mA at 9VDC. The
polarity of the power jack is center negative.
The maximum allowable power supply voltage
is 10.5 VDC.
Once power is applied, the 95000 begins its
startup procedure. The 4-digit LED display
shows the following:
1. “EHX 95000” scrolls across the display.
2. Then the firmware’s version number “V
x.y” will appear briefly to indicate the
currently loaded software version.
3. Finally, the screen settles on the last used
LOOP number and DUB setting for Track 1.
2. microSDHC Card Slot
Insert a microSDHC Memory Card in this slot to
store your loops.
3. USB Connector
Plug a standard USB cable into this port to
interface the 95000 with your computer.
4. MIDI OUT Connector
Use a standard 5-pin DIN MIDI cable with this
connector. When the EXT. CLOCK function is
off, the 95000 continuously generates MIDI
Clock and outputs it through the MIDI OUT jack.
Connect to MIDI OUT when you want the 95000 to
be the MIDI Clock master; you can slave another
device, such as another 95000, drum machine, 8-
Step Program sequencer, x0xb0x or beat box to
the 95000.
When either of the EXT. CLOCK modes is enabled,
the 95000 uses the MIDI OUT jack as a MIDI THRU
jack. Whatever messages the MIDI IN jack receives
are passed back through the MIDI OUT jack.
5. MIDI IN Connector
Connect a standard 5-pin DIN MIDI cable to this
connector to receive MIDI Clock, Control Change (CC)
and Program Change (PC) messages. When the EXT.
CLOCK function is enabled, the 95000 can sync to
MIDI Clock through the MIDI IN jack. You can use
another 95000, a drum machine, sequencer, x0xb0x,
beat box or any other device that outputs MIDI Clock
as the MIDI Clock master; the 95000 will slave to the
external device.
Using MIDI CC and PC messages, you can control nearly
every parameter on the top panel of the 95000. The
only controls not available via MIDI are the L and R
INPUT LEVEL knobs and the HEADPHONE LVL knob.
6. EXPRESSION PEDAL Jack
Connect an expression pedal with a 1/4" TRS plug to
the EXPRESSION PEDAL jack of the 95000. Use this
pedal to control the Master Level of the loop audio.
When an expression pedal is connected, the 95000
MASTER LVL knob sets the maximum volume that can
be achieved with an expression pedal. The expression
pedal only sweeps the volume of the loop audio—Tracks
1–6 and MIXDOWN. It does not sweep the volume of the
DRY audio present at the two input connectors.
Accepted expression pedals include:
 Electro-Harmonix Expression Pedal
 Electro-Harmonix Dual Expression Pedal
 Electro-Harmonix Next Step Expression Pedal
 Boss® FV-500L
 Moog® EP-3
 M-Audio® EX-P