User Manual

turned on using the FEEDBACK knob in secondary knob mode.

FEEDBACK controls modulation depth, and factory default is zero, with

the knob fully counterclockwise. Turn the knob up to increase

modulation. The DELAY knob controls modulation rate. Factory default is

0.75Hz, at the 10 o’clock position of the knob, which corresponds to the

Deluxe Memory Man’s Chorus setting. Set this knob to the noon position

to reach the DMM’s Vibrato setting.

TAPE – The DELAY knob controls the amount of tape distortion,

emulating an aging tape. Factory default is 10 o’clock. The FEEDBACK

knob controls Tape Flutter modulation depth. Factory default is 9 o’clock.

Turn both knobs to the minimum position for a clean, fresh tape tone.

VERB – The DELAY knob controls the reverb time. Factory default is 11

o’clock. Turn this knob up for longer reverb tails, turn it down for

shorter. The FEEDBACK knob controls a low pass filter on the reverb.

Factory default is set to maximum. Turn this knob down to get a darker

reverb sound.

OCT – Using Secondary Knob Mode, it is possible to get ascending

octaves, descending octaves, or both with the CANYON. The DELAY knob

controls the Up Octave (ascending). Factory default is the maximum

position. The FEEDBACK controls the Sub Octave (descending). Factory

default is the minimum position, in which the Sub Octave is muted.

SHIM – The DELAY knob controls a low pass filter on the shimmer

effect. Factory default is set to maximum (filter wide open). Turn this

knob down to get a warmer shimmer sound. The FEEDBACK knob

controls modulation depth. Factory default is set to 9 o’clock.

S/H – Similarly to MULTI mode, the DELAY knob controls volume

decay/swell on Sample/Hold mode. Factory default is set to 12 o’clock

with no decay or swell. If the knob is turned above 12 o’clock, the

echoes will begin silent and increase in volume until the level set by the

FX LVL knob. As the knob is turned up, the amount of time it takes to

reach full volume increases. If this knob is turned below 12 o’clock, the

repeats will decay. As the knob is turned down, the amount of time it

takes to reach silence decreases.

LOOP – No secondary knob functions.