User Manual

3
TAILS Switch – The CANYON allows you to choose whether delayed
echoes continue to repeat or stop immediately after the pedal is
switched to bypass. To control this, remove the CANYON’s bottom cover
and locate the small slide switch on the bottom of the board labeled
“TAILS.”
When Tails are set to ON, the echoes will continue to repeat after the
pedal is switched to bypass, with the number of repeats set by the
FEEDBACK knob. Anything you play after entering bypass will not repeat.
If the pedal is set for infinite feedback (i.e. the FEEDBACK knob is set to
maximum) the repeats will continue until you turn the FEEDBACK knob
down or switch to a different mode.
Note: In Sample/Hold mode, repeats will not continue indefinitely when
Tails are ON. The repeats will fade out over half a second.
When Tails are set to OFF, all repeats will stop as soon as the bypass
switch is pressed, regardless of the FEEDBACK knob setting.
- CONNECTIONS -
INPUT Jack – This ¼” jack is the audio input of the CANYON. The
input impedance is 1M.
OUTPUT Jack – This ¼” jack is the audio output of the CANYON. The output
impedance is 680.
TAP IN Jack – Connect an external momentary footswitch to this ¼”
jack to control the delay time by tapping in a tempo. The external switch
should be normally open. Upon engaging the switch, it should create a
short circuit between the Tip and Sleeve of the plug. See “Tap Tempo
with the CANYON” on page 7 for details on using Tap Tempo.
9V Power Jack – Plug the output of the CANYON’s supplied EHX9.6DC
200mA AC adapter in the 9V power jack located at the top of the pedal.
The CANYON requires 150mA at 9VDC with a center-negative plug.