User Manual

5
SHIM – Shimmer – This mode creates a shimmer effect, generating a
rich octave-shifted wash of harmony with your guitar. The CANYON
achieves this by modeling a chain of four EHX pedals:
S/H – Sample and Hold – This mode senses guitar plucks, and repeats
them indefinitely until another pluck is sensed. In this mode, the
FEEDBACK knob controls the CANYON’s sensitivity to guitar plucks. At
the minimum position, only the strongest plucks will trigger the S/H
mode. As FEEDBACK is turned up, the sensitivity of this mode increases.
LOOP – Looper mode – When the CANYON is in LOOP mode, it becomes
a looper pedal with a maximum loop length of 62 seconds. A recorded
loop is stored permanently, even when the CANYON is removed from
power. As a special feature, the FEEDBACK knob controls the level of the
existing loop that is preserved when overdubbing.
- USING THE CANYON’S LOOP MODE -
RECORDING A LOOP
1. To record a loop, press the footswitch once. The LED will light red
and recording begins immediately.
2. To stop recording the loop, press the footswitch again once. The
LED will light green, and the loop will begin playing immediately.
3. The FX LVL knob controls the output level of loop playback. Your dry
signal remains at unity signal level.
4. The loop plays indefinitely. Each time the loop repeats, the LED will
briefly turn off.
5. Note: If the full 62 seconds of loop recording time is reached,
recording will stop automatically.