User Manual

options, each indicated by the LED color. If you tap in a quarter-note

tempo, the tap divide subdivisions will be:

 Red LED: quarter notes (no division)

 Orange LED: dotted eighth notes (3/4 of tapped delay time)

 Green LED: eighth notes (1/2 of tapped delay time)

USING THE INTERNAL FOOTSWITCH

Tap the CANYON’s internal footswitch at least two times at a steady

tempo. The delay time will be set to your tapping speed, divided by the

tap divide setting. The LED will blink at the rate of the delay.

Tip: When

you tap the internal footswitch, the CANYON will enter/exit bypass. If

you don’t want echoes to stop while setting tap tempo, make sure the

TAILS switch is set to ON, or use an external footswitch.

You can also disable the internal footswitch’s tap tempo function. This is

useful when you want to turn the pedal on/off very quickly. To

disable/enable internal tap tempo, unplug power from the CANYON,

press and hold the footswitch, then plug power back in while holding the

footswitch. The LED will slowly blink five times if tap tempo is turned off,

and will blink twice if tap tempo is turned on. The CANYON saves your

tap tempo enable/disable setting until it is changed again, even if the

pedal is removed from power.

Tip: If you set the Tails switch to ON and

disable internal tap tempo, you can quickly switch the CANYON in and

out of effect mode to “grab” individual notes or phrases to repeat, or to

keep high FEEDBACK settings from becoming too busy.

You can also reset the internal footswitch’s tap tempo to the factory

setting of enabled by holding the footswitch when resetting secondary

knob settings. See step 11 in “Using Secondary Knob Mode” below.

USING AN EXTERNAL FOOTSWITCH

Connect an external momentary footswitch to the TAP IN jack to control

the delay time by tapping in a tempo. The external switch should be

normally open. Upon engaging the switch, it should create a short circuit

between the Tip and Sleeve of the plug. Tap the external footswitch at

least two times at a steady tempo. The delay time will be set to your

tapping speed, divided by the tap divide setting. The LED will blink at the

rate of the delay.

Plugging in an external tap switch always disables the internal

footswitch’s tap tempo functionality.