User Manual

CHILLSWITCH
MOMENTARY LINE SELECTOR
Congratulations on your purchase of the Electro-Harmonix CHILLSWITCH.
– KILL SETUP –
– LINE SELECTOR SETUP –
In this setup, the CHILLSWITCH allows you
to quickly switch between mute and unmute
by pressing the footswitch, resulting in a
hard rhythmic tremolo effect.
In this setup, the CHILLSWITCH allows you to
quickly switch between an effects loop and
your dry signal by pressing the footswitch.
Depending on the effects in the loop, it could
trigger a burst of distortion, or perhaps a foot-
controlled delay feedback… the possibilities are
endless!
INPUT JACK – Connect to the output of
your instrument or another effects pedal
INPUT JACK – Connect to the output of your
instrument or another effects pedal
SEND JACK – Disconnect
SEND JACK – Connect to the input of your
effects loop
RETURN JACK – Disconnect
RETURN JACK – Connect to the output of
your effects loop
AMP JACK – Connect to the input of your
amplifier or another effects pedal
AMP JACK – Connect to the input of your
amplifier or another effects pedal
- LED INDICATOR –
In either setup, the LED reflects the signal present at the AMP jack.
LED OFF – The AMP jack outputs the original INPUT signal
LED ON – The AMP jack outputs the signal from the effects loop (or no signal, in Kill Setup)