User Manual

11
not change the playback speed of the other loop or the Rhythm loop. You can
playback and overdub in any of the Octave modes.
Half Speed: Upon pressing the OCTAVE button to activate half speed, the 4-digit
display shows the word “down” for about 1 second. When set to half speed, the
pitch of the loop goes down 1 octave and the tempo is halved. Exactly like
playing a tape at half speed.
Double Speed: Press the OCTAVE button again to activate double speed. The 4-
digit display shows the word “UP” for about 1 second. When set to double
speed, the pitch of the loop goes up 1 octave and the tempo is doubled. Exactly
like playing a tape at double speed.
TRIGGER LEDs – Loop A and B each have a white LED situated between the
REVERSE and OCTAVE buttons. When illuminated these LEDs indicate that
TRIGGER mode is activated for their respective loop. These LEDs blink when
they are waiting for an input signal to exceed their trigger threshold to start loop
recording. See more on TRIGGER mode, page 21.
LOOP A & LOOP B FSWs – These two footswitches (FSWs) control much of the
activity for their respective loops. If you start with an empty loop, the following
actions can be performed by pressing either of the Loop FSWs:
Press Loop FSW once > Start Recording Initial Loop >
Press Loop FSW once > End Recording and Set Loop Length, Immediately Start Playback >
Press Loop FSW once > Start Overdubbing >
Press Loop FSW once > End Overdubbing, Continue to Playback Loop >
Press and Hold Loop FSW for 1.5 Seconds > Undo Last Overdub > Release FSW >
Press and Hold Loop FSW for 1.5 Seconds > Redo Last Overdub > Release FSW >
Double Tap Loop FSW > Stop just the Loop associated with the FSW >
Press Loop FSW once > Start Loop Playback
STOP/TAP FSW – The STOP/TAP FSW performs the following 3 functions: Stop
Everything, Start/Stop Rhythm loops, Tap Tempo. The STOP/TAP FSW function
can be changed by enabling or disabling the RHYTHM and TAP ON buttons
above the FSW. See the table on the following page for more information.
RHYTHM Button – When this button glows orange RHYTHM is enabled and the
STOP/TAP FSW starts and stops the Rhythm loop. See the table on the following
page for more information.
TAP ON Button
– Press this button to enable/disable TAP ON and allow the
STOP/TAP FSW to perform tap tempo for the loops and Rhythm. See the table
on the following page for more information.