User Manual

16
- SIGNAL PATH -
Left/Right Audio Paths – The Left and Right channels remain separate
throughout the 22500.
Signals input through either the L/MONO ¼” jack or the XLR MIC connector are
recorded onto the left channel of each loop. The loop’s left channel is output
through the L/MONO output jack only. You cannot record L/MONO ¼” jack or
XLR MIC inputs simultaneously. Use the LEFT INPUT toggle switch to choose one
or the other. When LEFT INPUT is set to INST, the L/MONO ¼” jack connects to
the input of the loop recorder. The MIC setting connects the XLR input to the
loop recorder.
Signals input through the R ¼” input jack are recorded onto the right channel of
each loop. The loop’s right channel is output through the R output jack only.
Use the EHX Pan Pedal, mixer, or audio workstation with the outputs of the
22500 to create a stereo mix-down for a variety of applications.
Stereo Looping – The 22500 always records each loop in stereo, no matter
your settings or the connections to the input/output jacks.
- EXPLANATION OF MODES -
• Press and release the MODE knob to enter in and out of modes.
• When a particular mode LED is lit solid, then the mode is selected.
• If a mode LED is blinking, no mode is selected. Turn the MODE knob to
scroll through all the modes.
• When you land on the MODE you want to adjust, press and release the
MODE knob to enter into the mode. The selected LED goes solid.
• At this point you can turn the MODE knob to adjust its value. After you
have adjusted the value, press and release the MODE knob to exit out
of the mode. The selected MODE LED blinks.
NAVIGATING THROUGH THE MODES
– The MODE-encoder knob is used to
navigate around the 8 Modes. While any of the 8 Mode LEDs is blinking, turning
the MODE knob in either direction will cycle in a circular fashion through all the
modes.