User Manual

20
b: beat, quantizes loop lengths to the nearest beat. You can make your loop any
number of beats in length. The 22500 begins recording the loop on the following
beat after you press either the Loop A or Loop B FSW and ends the loop on the
first beat after you press either FSW. We consider b Quantize to be an expert
setting and is best attempted after you have mastered one of the other Quantize
settings. NOTE: Both the RHYTHM and TAP ON LEDs blink on every beat.
Digit 4 – Parallel or Sequential Modes – P or S: Digit 4’s setting determines
how Loop A and Loop B interact with each other when recording, overdubbing
and playing back.
P: Parallel Mode: Loop A and Loop B playback simultaneously. Additionally one
loop can either be recording or overdubbing while the other plays, both loops
cannot record or overdub at the same time. When Digit 1 is set to F, Loop A and
B are independent of each other so the 22500 can be used like two loopers in
one unit. Set Digit 1 to L for Loop-Lock mode and the 22500 acts like a 2-track
recorder where Loop B’s length is set by Loop A and the two loops play back in
sync with each other.
S: Sequential Mode: Only one loop plays, records or overdubs at a time. Sequen-
tial mode works best when you want to change from one loop to another without
any gaps, for use in verse/chorus situations or A/B parts. When Digit 1 is set to F
and Digit 3 to n, Non-Quantize, the loops change instantly when you press the
FSW of the loop currently not playing. If you set Digit 3 to any of the Quantize
modes, the loops change over on the next beat 1, or the next beat if Digit 3 is b.
If you set Digit 1 to L, no matter the setting of Digit 3, loops change over when
the loop currently playing reaches its end.
1-SHOT Mode – When enabled, 1-Shot plays a loop in its entirety just once.
When the end of the loop’s audio is reached – whether recording, playing or
over-dubbing – the loop goes into Stop mode automatically. NOTE: While 1-Shot
is enabled: after recording an initial loop, the loop stops immediately and does
not playback once. You must press the loop’s FSW to hear the loop.
LOOP Mode: Page 2, LOOP A 1-SHOT Setting – Page 2 of LOOP mode
enables/disables 1-Shot mode for Loop A. The display shows A1oF when 1-Shot
mode is turned off or A1on when 1-Shot is enabled.
LOOP Mode: Page 3, LOOP B 1-SHOT Setting – Page 3 of LOOP mode
enables/disables 1-Shot mode for Loop B. The display shows B1oF when 1-Shot
mode is disabled or B1on when 1-Shot is enabled.