User Manual

22
6. Press Loop A’s FSW to end loop recording. Stop recording the loop
in the same way you would when not using Trigger.
7. Disable TRIGGER by decreasing its setting so that the display
shows “oFF”.
R TEMPO Mode – R(hythm) TEMPO mode displays the current tempo in BPM
and allows for tempo adjustment. Select R TEMPO and turn the MODE knob to
change tempo. As you do so, both Loop A and B and the Rhythm loop will follow
along with the tempo change. Loop A and B do not change pitch as you adjust
tempo but the Rhythm loop does.
If tempo has been adjusted since recording a Loop Bank’s first loop – either by
tapping in a new tempo or by rotating the MODE knob – press and hold MODE
for about 1.5 seconds, while R TEMPO is lit or blinking. The 22500 will jump back
to the original tempo.
R TYPE Mode – R(hythm) TYPE mode allows you to choose the current Rhythm
loop. The 22500 comes supplied with 16 Rhythms from the factory, in locations
01–16. The Rhythms are stored on and played from the SD Card (see R LEVEL
below for steps on restoring the Rhythm loops to a new card). Rhythm loops are
for playback only, they cannot be overdubbed.
The display shows three digits: Digit 1, which is not adjustable indicates the time
signature for the Rhythm loop (2 = 2/4, 3 = 3/4, 4 = 4/4, 6 = 6/8). Digits 3
and 4 show the current Rhythm type. From the factory 01 to 16 are available but
you may add any Rhythm loop between 00 and 99, as the 22500 can playback
user Rhythm loops. See “Importing Audio Files for RHYTHM Loops” on page 26
for information on preparing and importing Rhythm loops.
R LEVEL Mode – R(hythm) LEVEL mode contains 2 pages. The first page is
where you set the volume for the Rhythm loop. The range is from 0–100 with
100 being the loudest. R LEVEL’s second page is called “COPY”. When you
insert a new SD Card into the 22500, it normally would not contain the factory
default Rhythm loops. The COPY function copies the factory Rhythms to the SD
Card. Here’s how to perform the COPY function:
1. Go to Page 2 of R LEVEL mode so that the word “COPY” is
displayed.
2. Press and release the MODE knob. R LEVEL’s LED should be lit solid.
3. Ensure an SD Card is inserted into the 22500. NOTE: if the SD Card
contains Rhythm loops in locations 01–16, they will be overwritten when
performing the COPY function.