User's Manual

EXT FOOTSWITCH FUNCTIONS

The EXT input jack on the PITCH FORK

+ provides expanded control with

an external foot controller, such as the EHX Triple Foot Controller or

Digitech

FS3X. Using a TRS cable, connect the foot controller to the EXT

input. Now use the external foot controller to change modes, enter/exit

sub-menus, load presets, and scroll through parameter values.

The foot controller has three footswitches, Mode (Tip), Up (Ring) and

Down (Tip+Ring). The footswitches function as follows:

MODE (Tip) – This footswitch can be used to cycle through the eight

Mode buttons, enter/exit a sub-menu and load presets.

• Cycle through modes: A single press when a mode main-menu is

displayed selects the next mode button.

• Enter sub-menu: Quickly double press the mode footswitch.

• Exit sub-menu: Single press to go back one menu level.

UP (Ring)/DOWN (Tip+Ring) – These two footswitches can be used

for scrolling through parameter values and menus:

• Increment: A single press and release on the Up footswitch

increments the current parameter value by one.

• Decrement: A single press and release on the Down footswitch

decrements the current parameter value by one.

• Quick Scroll Increment: Press and hold the Up footswitch to scroll

upwards through values at a faster rate for certain modes and

sub-menus listed below.

• Quick Scroll Decrement: Press and hold the Down footswitch to

scroll downwards through values at a faster rate for certain modes

and sub-menus listed below.

Quick scrolling works within the following modes/menus: SHIFT 1&2,

DETUNE 1&2, JUMP, 1->2, 1<-2, PRESET, RISE and FALL. While quick

scrolling in PRESET mode, once the desired preset is reached, tap either

UP or DOWN to load the selected PRESET if it is valid. A valid/non-empty

preset slot will have a dot in the lower right corner.