User's Manual

4
CONTROLS & DISPLAY
DRY Knob – Controls the volume level of the DRY signal.
SHIFT 1 Knob – Controls the effect volume level of SHIFT 1.
SHIFT 2 Knob – Controls the effect volume level of SHIFT 2.
VALUE Knob – VALUE is a rotary encoder that can rotate continuously in
either direction, and be pushed like a button. VALUE will adjust the
selected mode parameter, enter sub-menus, or save presets to memory.
A press of VALUE enters sub-menus when applicable. Holding VALUE when
in PRESET mode saves a preset.
4-Character Display – The 4-character display shows the current
parameter value or menu setting for the selected mode. The display shows
which option is selected within a mode menu or sub-menu.
When there is a dot in the lower right corner of the display, for example
“ FREQ. ”, this signifies there is a sub-menu that can be entered. Enter a
sub-menu by pressing VALUE or a double-tap of the MODE (Tip) FSW on
an external foot-controller.
BYPASS Footswitch and LED – The BYPASS footswitch toggles
between effect on and buffered bypass. In latch mode, each press and
release of the footswitch toggles between effect and bypass modes. In
Momentary mode, when the footswitch is held down, the glissando effect
is on, when the footswitch is released, the PITCH FORK
®
+ enters bypass.
The status LED lights when in effect mode or when glissando is active.
USER Footswitch and LED – The USER footswitch’s function is
programmable when the USER mode button is selected. The USER
footswitch works independently from the BYPASS footswitch and has its
own status LED. When the LED is lit, an effect or feature is enabled. When
the USER footswitch LED is off, then the effect or feature is disabled or
not in use.