User's Manual

9
USER Mode – The user programmable footswitch can be assigned to
control different parameters or augment certain features.
For BLND, 1XF2 , 1X2D , D1X2 and 1XS2 , holding down the footswitch
will behave like a pseudo expression pedal. The crossfade rate for these
modes is set within the RISE and FALL sub-menus under MOME in
LATCH mode. When using one of these five USER modes, the BYPASS
footswitch changes to LATCH mode, even if MOME is currently selected.
When the USER footswitch is assigned to control frequency or volume,
that function is disabled for use with the EXP jack. Also, USER 1XS2 takes
precedence over EXP’s FREQ 1XS2.
▪ AUXO. – Toggles the AUX Output. Press VALUE to enter the Aux
output control sub-menu. When selected, AUXO takes
precedence over BYPS settings within AUX.
• BYP – Will toggle between the input signal and the AUX
output setting
• MUTE – Will mute the AUX output when USER is toggled
OFF
▪ SHF1 – Will toggle SHIFT 1 channel’s ON/OFF
▪ SHF2 – Will toggle SHIFT 2 channel’s ON/OFF
▪ JUMP. – Turn VALUE to choose a preset slot ranging from 1-100.
When the USER footswitch is pressed, preset will jump to and
load the selected slot if a valid preset is selected. Any number of
presets can be chained together. These preset chains can then be
closed to create a loop of presets that are cycled through with
each press of the USER footswitch. See page 10 on how to setup
a preset chain with JUMP.
▪ HOLD – If momentary (MOME.) is selected in LATCH mode, a
glissando (glide) occurs at a programmed rate when BYPASS is
pressed. When USER is set to HOLD and the USER footswitch is
pressed, during a glissando sweep, the glissando pitch is held at
the point when the USER footswitch was pressed. Releasing the
USER footswitch continues the glissando cycle.
▪ BLND – Blends from DRY to both SHIFT channels
▪ 1XF2 – Crossfade from SHIFT 1 to SHIFT 2
▪ 1X2D – Crossfade from SHIFT 1 to SHIFT 2 with DRY control
▪ D1X2 – Crossfade from SHIFT 1 with DRY control to SHIFT 2
▪ 1XS2 – Cross-shift and crossfade SHIFT1 to SHIFT 2