User Manual

DOUBLER – Doubletracking effect

Doubler is a short delay, a detuner, and a stereo spread effect that is great

for thickening up a mono signal or widening it to stereo. The maximum

delay time is 150ms. The delay times of each stereo output may be offset

from each other and up to +/-50 cents pitch shift can be applied to the

signal. The delay time range of the DELAY knob is 0 to 50ms. TAP tempo

and TAP DIV functions are not available for DOUBLER. This mode works

differently with PING PONG engaged versus disabled, please read below

on using the OFFSET TIME knob.

TIP: To take full advantage of mono to

stereo conversion, the PING PONG button must be enabled and you must

use both outputs.

OFFSET TIME: Adds an offset delay time to the left or right outputs.

At the 12 o’clock position no offset time is added so the left and right

outputs have the exact same delay time.

PING PONG ON: As OFFSET TIME is turned counter-clockwise

from noon, the left output’s delay time increases up to three times

the delay time set by the DELAY knob. In this case, the right

output’s delay time is equal to the DELAY knob. As OFFSET TIME

is turned clockwise from noon, the right output’s delay time

increases instead, while the left output’s delay time is set by the

DELAY knob.

PING PONG OFF: Both outputs have the same delay time and

pitch detune amount. At the noon position no delay offset time is

added but both positive and negative detuned pitch shifting can be

heard. As the OFFSET TIME knob is turned counter-clockwise,

detuning goes positive while the delay time increases up to three

times the delay time set by the DELAY knob. As OFFSET TIME is

turned clockwise from noon, the detuner goes negative while delay

time increases by up to 3 times the DELAY knob setting.

Note: in

this setup, the echo set by the DELAY knob does not go through

the detuned pitch shifter nor does it have feedback applied to it.

Only the delay set by the OFFSET TIME knob goes through the

detuner and the feedback loop. This allows for an effect where the

first repeat differs from the repeats that follow.

PITCH SPREAD: Sets the amount of micro-tonal, detuned pitch shift

for each output, from no detune in the counter-clockwise position to

full detune (+/- 50 cents) at the fully clockwise setting.

PING PONG ON: The left output’s detune always goes positive

while the right output’s detune always goes negative.

PING PONG OFF: Both outputs have the same detune setting.

The OFFSET TIME knob sets the direction of the detuner.