User Manual

29
CREATING CUSTOM EXPRESSION SETTINGS
Your Grand Canyon comes set up from the factory with some useful
Expression Settings for each Delay Type, but you might want to create
your own. Here’s how to create custom Expression Settings:
1. Turn the DELAY TYPE knob to select the delay mode for which you
want to create a custom Expression Setting.
2. Press and hold the EXP MODE button. After one second, the other
illuminated buttons (such as TAILS) will blink.
3. Once the other buttons stop blinking, release the EXP MODE button.
EXP MODE will now be blinking at a medium rate.
4. Set any of the Grand Canyon’s six knobs to the position you want them
to have at the expression pedal’s heel position. If you do not want a
knob to be swept by the expression pedal, do not move it at this point.
Note: the only knob that cannot be controlled by an expression pedal
is DELAY TYPE.
5. Press and release the EXP MODE button to save the heel settings. EXP
MODE blinks rapidly now.
6. Set the six knobs to the positions you want them to have at the
expression pedal’s toe down setting. Again, if you do not want a knob
to be swept by the expression pedal, do not turn it.
7. While setting the knobs for toe-down position, you can move the
expression pedal to hear how the Expression Setting will sound.
8. You can go backwards to set the heel-down position again by pressing
& holding EXP MODE for 2 seconds.
9. Once you have set the knobs for the toe-down position, press and
release the EXP MODE button to save the toe settings.
10. The EXP MODE button will light solid and your custom Expression
Setting for the currently selected Delay Type is now saved and ready
to use. It will remain saved even after powering down the pedal.
11. Repeat these steps if you want to update the Expression Setting.
12. Press and release the DELAY TYPE knob at any time to cancel out of
Expression Setting setup without saving.
ERASING CUSTOM EXPRESSION SETTINGS
1. Turn the DELAY TYPE knob to select the delay mode for which you
want to restore the factory default Expression Setting.
2. Press and hold the EXP MODE button. After one second, the other
illuminated buttons (such as TAILS) will blink.
3. While the other buttons are still blinking, tap the BYPASS/STOP
footswitch.
4. The other illuminated buttons will stop blinking. The Expression
Setting is now restored to the factory default. You can now release
the EXP MODE button.