User Manual

31
You can also disable the BYPASS/STOP footswitch’s tap tempo function
in Delay+Looper mode. To disable/enable this function:
1. Unplug the Grand Canyon from power.
2. Press and hold the BYPASS/STOP footswitch while plugging power
back in to the Grand Canyon.
3. The BYPASS LED will flash 7 times if tap tempo is disabled. The LED
will flash 2 times if tap tempo is enabled.
4. If the Grand Canyon is reset to factory defaults (see page 35), the
BYPASS/STOP footswitch’s tap tempo functionality will be enabled in
Delay+Looper mode.
USING AN EXTERNAL FOOTSWITCH FOR TAP TEMPO
When the Grand Canyon is set to Delay or Delay+Looper modes, an
external momentary footswitch may be used to set tap tempo. The
external switch may be either a single button with a TS plug, or a double
or triple button unit with TRS plug. The external switch needs to be
normally open. Upon engaging the switch, it should create a short circuit
between the Tip and Sleeve of the plug to be used for tap tempo. Follow
these instructions to tap in the delay time with an external footswitch:
1. While powered down, connect an external momentary footswitch to
the Grand Canyon’s FSW jack.
2. Power up the Grand Canyon. Set to Delay or Delay+Looper modes.
3. Tap the external footswitch at least two times at a steady tempo. The
delay time will be set to your tapping speed, divided by the Tap Divide
setting.
4. The currently selected TAP DIV LED(s) blink at the rate of the current
delay time.