User Manual

32
PRESET USE AND SETUP
The Grand Canyon can save and recall one preset per Delay Type plus a
preset for Looper mode. Each preset saves all current knob settings, the
current Expression Settings, Tap Tempo, Tap Divide, all illuminated button
settings, and secondary mode status if you are in Pitch or Drum modes
(see page 34). Presets do not save loop audio.
SAVING PRESETS TO A DELAY TYPE
The Grand Canyon must be in either Delay or Delay+Looper mode to save
a Delay Type preset.
1. Turn the DELAY TYPE knob to the specific Delay Type that you want
to save to.
2. Set up the sound you want to save.
3. Press and hold the DELAY TYPE knob for two seconds.
4. You will soon see the PRESET LED blink rapidly. Continue to hold
down DELAY TYPE until the PRESET LED stops blinking.
5. The preset is now saved. You can release the DELAY TYPE knob.
SAVING A PRESET FOR LOOPER MODE
1. Press the mode button so that only the LOOPER LED is lit.
2. Adjust the knobs and buttons to your preferred settings.
3. Press and hold the DELAY TYPE knob for two seconds.
4. You will soon see the PRESET LED blink rapidly. Continue to hold down
DELAY TYPE until the PRESET LED stops blinking.
5. The Looper preset is now saved. Release the DELAY TYPE knob.
RECALLING PRESETS USING THE DELAY TYPE KNOB
The Grand Canyon must be in either Delay or Delay+Looper mode to recall
a Delay Type preset. It must be in Looper mode to load the looper preset.
1. Turn the DELAY TYPE knob to the Delay Type that you want to recall.
If you want to recall a Looper preset, press the small Mode button so
that only the LOOPER LED is lit.
2. Press and release the DELAY TYPE knob. The PRESET LED lights
indicating the preset has been loaded.
3. Once a preset is loaded and the PRESET LED is lit, changing to other
Delay Types or to Looper mode automatically recalls their presets. To
disable presets, see the section on the following page entitled
UNLOADING PRESETS.